Packard 1933 - Service Film Supplement on Introducing the Tenth Series - Vol II Supplement 1

18 page all new reprint; digitally restored from the original source and printed on high quality 8.5" x 11", 32#, 97 bright acid free paper in Black & White, assembled into an individual item that is folded and stapled, or heat bonded with an adhesive fabric binding.

Contents - Index:

• Pages: 18

• Packard 1933 - Service Film Supplement on Introducing the Tenth Series - Vol. II Supplement 1
• Packard Motor Car Co
• Packard Motor Company
• Packard Tenth Series
• General Information
• Interior & Exterior Images
• As we enter the year of 1933 with Packard ...
• This is the Ten 0 Two
• This is the Packard Eight, Ten 0 One ...
• The Packard Super Eight, or Ten 0 Three is ...
• The Super Eight or Ten 0 Four Chassis will ...
• The Packard Twelve or Ten 0 Six has ...
• The Packard Twelve or Ten O Five has ...
• The height of the radiator has ...
• Full Type bumpers are used in ...
• The cushions and seat backs have been ...
• Packard body ventilation is ...
• The front compartment is roomy and ...
• The instrument board has been ...
• The left side view of the motor ...
• The Packard Eight Power Plant is ...
• The new front motor mounting uses a ...
• The rear of the motor is on ...
• Front end drive is accomplished through ...
• We have retained our rigid crankshaft ...
• Another improvement in our Eight motor ...
• Manifold, dual carburetor, air cleaner and ...
• We are using two coils whose location ...
• The mechanical fuel pump combined with a ...
• Attached inside the right glove compartment ...
• A new connecting rod provides ...
• The Packard Twelve power plant develops ...
• A change has been made in the ...
• The rigid crankcase and shaft ...
• Observe the difference between these ....
• On the Packard Twelve we have what is ...
• The Packard transmission is of the ...
• The Packard clutch as used on the ...
• Angle set rear axle is used through ...
• The bearings in the axle ...
• An angle set rear axle permits the use of ...
• The Packard Twelve steering gear is of a ...
• On the Packard Eight and Super Eight the ...
• The Packard Steering gear is of the worm ...
• To control the operation of the vacuum ...
• ENGINEERING SPECIFICATIONS:
• Packard 8 Model 1001 - 1002
• Packard Super 8 Model 1003 - 1004
• Packard 12 Model 1005 - 1006
• Complete Car Weights
• Standard Equipment
• Front axle and steering knuckle ...
• This adjustment is made through a ...
• The brake drums are a composite of ...
• The Packard frame is of pressed steel ...
• The frame X member has ...
• The shock absorbers are two way ...
• Packard automatic chassis lubrication is ...
• Also built into the shock absorber is a ...
• We have shown you many features ...