Johnson 1940 - 1940 Johnson Sea Horse Motor Manual
46 page all new reprint; digitally restored from the original source and printed on high quality 8.5" x 11", 32#, 97 bright acid free paper in Black & White, assembled into an individual item that is folded and stapled, or heat bonded with an adhesive fabric binding.
Contents - Index:
- Pages: 46
- Johnson 1940 - 1940 Johnson Sea Horse Motor Manual
- Johnson Motors
- 1940 Johnson Motors Sea Horse
- General Instruction Book for Johnson Sea Horse Outboard Motors
- Part No. 300274 NSP-10-40-5M
- Johnson Service
- Warranty, Foreword
- Specification Chart
- The Two Stroke Cycle
- Fuel Mixture
- Attaching the Motor to the Boat
- Thrust Socket Adjustment
- The Co-Pilot
- Adjustment of Swivel Bracket
- Mounting Motor on Canoe
- To Break in New Motor, Starting, Controls
- Lubrication and Care of the Gearcase
- Starting Mixture, Model LT Illustration
- Starting Instructions for Models LT, DT and AT
- Starting Instructions KA
- Model DT Illustration
- To Start Model SD
- Model KA Illustration
- To Start Model PO, The Ready Pull
- Model SD Illustration
- Model PO Illustration
- Care of the Ready Pull
- To Install New Starting Cord
- Compression Release and By-Pass Valve – PO Only
- Carburetor Adjustment Models KA and PO
- Models LT, AT and DT
- Steering and Reverse
- Co-Incidental Exhaust Cut-Out
- Automatic Exhaust Cut-Out – Model PO Only
- The Magneto, Care of the Magneto
- Spark Plugs, To Remove Flywheel
- To Install Flywheel
- The Shock Absorber
- To Install Drive Pin
- The Cooling System
- Care of the Cooling System
- Propellers, Cavitation
- Care of the Motor
- Hard Starting is Caused By:
- Failure to Start
- If Motor is Dropped Overboard
- Preparation for Storage
- Preparation for Spring Operation
- Index